EV charger installation in Asheville, NC
A Level 2 charger turns an overnight trickle into a full battery by morning. We size the circuit to what your panel can actually carry, run it cleanly to your garage or driveway, and pull the permit when the job needs one.
What the install includes
A load check on your existing panel, a dedicated 240-volt circuit sized to the charger, conduit or cable run to the mounting spot, the breaker, and testing with your car plugged in. If the panel is near the garage the job is usually done in a few hours; long runs to a detached garage or a driveway post take longer, and the estimate shows that.
Tesla, ChargePoint, Emporia and other chargers
We install Tesla Wall Connectors and the common hardwired and plug-in Level 2 units. Bring your own charger or ask us for a recommendation that fits your panel. Hardwired chargers avoid the wear and heat problems a 14-50 outlet can develop with daily use.
When the panel is the limit
Older 100-amp services are often already close to full. We measure the load first; if there is not enough headroom we will tell you before any work starts, and price the options: a lower-amperage charger setting, load management, or a panel upgrade.
Where we install
Homes across Buncombe County, including Asheville, Candler, Arden, Fairview, Weaverville, Black Mountain, Leicester, Swannanoa and Biltmore Forest. The on-site assessment is free inside the county.
What it costs
| Level 2 charger install — near panel | $600–$1,500 |
|---|---|
| Level 2 charger — long conduit run | $1,200–$2,500 |
| Tesla Wall Connector install | $650–$1,600 |
Ranges from our published price book. Your exact number is confirmed on site before any work starts.
Questions we get
How much does it cost to install an EV charger in Asheville?
Most installs near the panel fall in the lower range shown on this page; long conduit runs and detached garages cost more. Our instant estimator gives you a range for your exact setup in seconds, and the on-site visit confirms it before work starts.
Do I need a permit for a Level 2 charger in Buncombe County?
A new 240-volt circuit generally needs an electrical permit and inspection. We pull the permit on every job that needs one and schedule the inspection.
Can my panel handle an EV charger?
Often yes, but not always. We do a load calculation on your panel before installing, and we set the charger's amperage to what the panel can safely supply.
We do ev charger installation across Buncombe County. See all service areas.